HalfShade JL Instructions

Instructions for the GearShade HalfShade JL & JLU Top:

The JL GearShade top comes with specially designed bungees. Consisting of a bungee loop and a special clip.

 

At one front corner of the Jeep. Loop the attached corner bungee cord over and around the outside of the roll cage. Then back UP through the corner grommet hole. Now stretch the bungee and clip it to the open hole in the windshield bar. (See Photos)

 

Working  backwards from the front, pass the bungee clip through itself. Now attach the clip to the grommet hole, pulling outward. You will hear a “click” when it is ready. It may take a small bit of force to get the clip to click on to the grommet.

Bungee MUST be as pictured above, to keep the mesh at the top of the roll cage.

Work to the rear of the Jeep and attach the remaining bungees the same way.

At the back corner of the GearShade top, stretch the cord to the body seam on top of the sound bar. See the photo below. This “can” be down without taking off the hard top. But we recommend you remove all hard top bolts and lift slightly to attach these rear cords.

 

To remove the clip from the grommet hole, rotate the clip inwards to the hole. It will unlock, then pull it out.